915 type floor board machine

915 type floor board machine

915 type floor board machine features and uses:
The steel floor slab produced by the 915-type floor board machine is used for high-rise floor panels, featuring high peak height and high strength, high automation and low cost.

The steel floor slab produced by the 915-type floor slab is simple in shape, large in wave width and high in strength. It is assembled with concrete slabs after installation, and has good adhesion. It can be omitted on high-rise buildings. The steel formwork can also reduce the load on the floor and raise it before reaching the same bearing capacity, so that the amount of steel used in the project is reduced, thereby saving investment.

915 type floor plate machine operation and precautions: manual blanking, blanking work procedure: Before using the equipment, check whether the connection is firm, whether the installation bolts and nuts are tightened, and the left and right chassis should be filled with lubricating oil to power Start the machine to test the car, first observe the empty car operation, whether there is vibration, noise, whether the oil window comes to the oil, whether the movement of each component is coordinated, the mold can be installed after everything is normal, when the mold is installed, the power supply needs to be cut off, and the motor is manually moved. The belt or the large gear rotates the worktable and raises the slide to the highest point. It is best to use an object to support between the workbench and the bottom surface of the slide, so that the anti-slip seat naturally falls and causes an accident. The mold used in this machine needs one upper mold and six lower molds of the same size. First, the upper mold and one lower mold are installed. The lower mold is directly mounted on the hexagonal runner table, and the upper mold is mounted on the bottom surface of the slide.

Place a pad of appropriate thickness to ensure that the gap between the upper and lower dies is uniform after the upper and lower dies are closed, and the distance between the upper and lower dies is equal to the thickness of the required slab. Then the upper mold is prevailed, the workbench is indexed, and the remaining five lower molds are installed. After all the upper and lower molds are installed, the brake can be driven. Automatic discharging, blanking work procedure: mold installation and host test the same as above, then open air compressor, vacuum pump, extruder, cutting machine, discharge machine, tile machine, main machine and tile conveyor, when parking , stop the extruder first, then stop the rest of the equipment.